ClearSpan 104903 조립 지침 매뉴얼 - 페이지 7

{카테고리_이름} ClearSpan 104903에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearSpan 104903 19 페이지. Premium solar star greenhouse

View shows the inside of frame.

HINT: When installing panels, use a clamp at the top

and bottom corners (when possible) to clamp the panels

together before installing the flat brackets.

6. Move to the remaining back corner and install

another angled panel and a rectangular side panel

as shown below and secure these as before.

7. Using the above diagram, position a pass-through

connector on the frame tube in the locations

identified by the arrows.

Visit www.ClearSpan.com for additional products and customer assistance.

Side Panel

Pass-Through

Connector

NOTE: The raised portion of the pass-through connector

is positioned to the inside of the greenhouse.

8. Choose the center, non-door end panel, set it in

place, and install 3" x 3" square plates to secure the

panel seams. See the X's for square plate locations.

NOTE: Adjust the base frame tubes as needed to allow

the panels to fit properly. Reposition the pass-through

connectors on the end frame tube as needed and fasten

these to the non-door end panels.

9. Position additional pass-through connectors on the

side frame rails (see arrows below) and set the

remaining rectangular side panels in place as

shown.

10. Secure the panels to each other using 3" x 3" square

flat brackets and to the pass-through connectors.

DO NOT SECURE ANY PASS-THROUGH

CONNECTORS TO THE METAL BASE FRAME AT

THIS TIME.

11. Set the first angled, door end panel (X) into position

as shown above and secure the panel to the corner

frame bracket and to the side panel.

12. Move to the other side of the door opening, place

the final angled panel in position, and fasten it to the

corner bracket.

See diagrams on the next page.

6 of 18