ClearSpan 104903 조립 지침 매뉴얼 - 페이지 9

{카테고리_이름} ClearSpan 104903에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearSpan 104903 19 페이지. Premium solar star greenhouse

Dashed line below shows where the trim of the upper

panel overlaps the top of the doorframe.

Retighten (Step 21)

19. Align the edges and ends with the lower panels and

secure the triangular panel using flat brackets. See

the diagrams above.

20. Secure the ends of each triangular panel to the

lower panels using 3/4" Tek screws and neo-bonded

washers. See Figure 1 (previous page).

21. Retighten the screws to secure the polycarbonate to

the frame of the triangular panel above the door.

DO NOT SECURE THE DOOR TO THE ASSEMBLED

FRAME AT THIS TIME.

22. Move to the inside of the frame and measure the

distance between the base rail at both ends and in

the middle. See the arrows below.

Top View of Frame

ATTENTION: Use a tie-down strap and ratchet (not

included) to keep the center of the base in place. See

Visit www.ClearSpan.com for additional products and customer assistance.

photo insert in the previous diagram. Remove strap after

installing the roof panels.

The distances indicated by the arrows in the previous

diagrams must be equal before you continue. The metal

base will move outward when the roof panels are

installed if the frame is not secured.

23. Once the greenhouse is assembled to this point,

return to each tube splice on the metal base frame

and install a Tek screw through the tubes at each

splice to secure the joint. This prevents separation of

the metal base frame.

Base Frame Tubes

24. Return to each pass-through connector and secure

these to the base rail before you continue.

25. After securing the base frame tube joints and pass-

through connectors, square the frame by measuring

diagonally from corner-to-corner.

Dashed line shows where to

add a tie-down strap to keep

the base rail from spreading.

View is from the top looking down on the frame.

3/4" Tek

Screw

8 of 18