Dixon Bayco 6500X 설치 및 운영 지침 - 페이지 4

{카테고리_이름} Dixon Bayco 6500X에 대한 설치 및 운영 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Dixon Bayco 6500X 5 페이지.

6200X and 6500X Tall Drop Elbows

Check Operation

1. Place elbow bottom end on service station adapter (elbow is

designed for use with 4" top seal adapter only).

2. Move operators handle to 11 o'clock the open/unclamped position.

3. Release and hold the safety latch if equipped with one. Move the

handle clockwise to 2 o'clock position for full clamping (lever cannot

be moved any farther).

3. Check locking arms on adapter. If the elbow is fitted with a safety

latch, make sure the stem pin is in the latch notch, preventing

movement of operating handle.

4. Release by moving handle to 11 o'clock. If fitted with safety latch,

lift the latch lever and operating lever at the same time.

Dixon Bayco drop elbows are tested at the factory and are in proper

working condition when shipped. Drop elbows are designed to be

tough and to provide long service with reasonable care and handling.

To ensure long service, Dixon Bayco elbows should not be thrown,

dropped or dragged; such actions may compromise the integrity and

reduce the service life of the product.

Inspection

Drop elbows can fail to operate if not properly maintained. If the

6200X / 6500X elbow develops any problems, remove from service

and contact your Dixon Bayco distributor describing the difficulty. The

distributor will provide further instructions repair and warranty of the

product.

Elbows should be inspected monthly. Check the main gasket seal,

the sight glass, and the flange where the base is attached to the

elbow body for any signs of leakage. Change seals if necessary.

Check the sight glass for cracks or damage and replace if needed.

Check and tighten all fasteners periodically. Lubricate the lever stem.

Check the bushings and replace if cracked or worn, and change if

required. Check operation as per above.

090086 R6

6200X & 6500X