Altrad BELLE WPX 3/30 운영자 매뉴얼 - 페이지 12

{카테고리_이름} Altrad BELLE WPX 3/30에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Altrad BELLE WPX 3/30 18 페이지.
Altrad BELLE WPX 3/30에 대해서도 마찬가지입니다: 운영자 매뉴얼 (19 페이지)

페이지 인쇄
Altrad BELLE WPX 3/30 운영자 매뉴얼
GB
WARNING
PRE-OPERATION CHECKS
•
Check your Water Pump before use and IMMEDIATELY replace any damaged parts.
•
Check the general condition of the hoses. Be sure the hoses are in suitable condition before connecting them to the pump.
Remember that the suction hose MUST be reinforced construction to prevent hose collapse.
•
Check that the hose connectors and clamps are securely installed.
•
Check that the strainer is in good condition and is installed on the suction hose.
•
Remove any excessive dirt or debris.
Place the Water Pump on firm level ground with the engine switched OFF.
•
•
Check the engine oil level. Low oil levels will result in the engine not starting.
•
Check the fuel level.
•
This equipment is likely to emit a Sound Power Level (LWA) of up to 105dB(A). Wear appropriate ear defenders.
•
Be aware of how to stop the Water Pump by use of the ignition switch.
Refer to the engine manuals provided for full pre-operation check.
PRIMING THE WATER PUMP
The Water Pump is self-priming, so no action is necessary here.
STOPPING THE ENGINE
To stop the engine in an emergency, simply turn the engine switch to the OFF position. Under normal conditions, use the following
procedure:-
1.
Move the throttle lever to the SLOW position.
2.
Turn the engine switch to the OFF position.
3.
Turn the fuel valve lever to the OFF position.
STARTING THE ENGINE
CAUTION
1.
Move the fuel valve lever to the ON position.
2.
To start a cold engine, move the choke lever to the CLOSE position.
To restart a warm engine, leave the choke lever in the OPEN position.
3.
Move the throttle lever away from the SLOW position, about 1/3 of the way toward
the FAST position.
4.
Turn the engine switch to the ON position.
5.
Pull the starter grip lightly until you feel resistance, then pull briskly. Return the
starter grip gently.
If the choke lever has been moved to the CLOSE position to start the engine,
6.
gradually move it to the OPEN position as the engine warms up.
CAUTION
Operating Instructions
Before you operate or carry out any maintenance on this machine YOU MUST READ and STUDY
this manual.
Before starting the engine ENSURE you are aware of how to turn the engine correctly.
The engine running speed is pre-set by the manufacturer and must not be adjusted.
12
Throttle Lever
Choke Lever
Fuel ON/OFF
Lever.