ClearView PowerBoards PB-DG-001 설치 및 사용 설명서 - 페이지 6

{카테고리_이름} ClearView PowerBoards PB-DG-001에 대한 설치 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearView PowerBoards PB-DG-001 9 페이지. For ram 1500 pick-up truck 2015-2018

페이지 인쇄

Installing control unit and wiring

IMPORTANT

Clearview recommend this to be completed by a professional. Incorrect installation may cause damage to

your vehicle and possible personal injuries.

Position ECU and Wiring Harnesses

1. Remove felt panel located under the Glove Box. (Need plastic removal tool.)

2. Open the Glove Box – unclip and remove.

3. Inside the opening from where the Glove Box was removed, in the top left-hand corner, locate the Block

of White Plugs

4. Locate the Clearview ECU inside the cardboard box and remove from plastic bag.

5. Unplug the 2 Wiring Harnesses from the

rear of the Clearview ECU. 1 x black plug,

1 x grey plug.

Page | 6

Due to Clearview Continuous Improvement Program, information may change without notice.

Clearview takes no responsibility for the result of incorrect use of these installation instructions.

PB-DG-001

PB-TA-001

April 2018