ClearView PowerBoards PB-TA-006 설치 지침 매뉴얼 - 페이지 9
{카테고리_이름} ClearView PowerBoards PB-TA-006에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearView PowerBoards PB-TA-006 18 페이지. Toyota landcruiser 300 series 2022-current
페이지 인쇄Fitting Instructions
Step 2
Installing control unit and wiring
2.1 Mount control unit in the passenger kick
panel area.
The control unit should not be placed in
the vehicle engine bay, as exposure to
heat and moisture may cause damage to
the unit.
2.2 Connect the motor wire harness (small
white power plug) and sensor wire harness
(large white plug) to the control unit.
Once connectors are plugged in, leave in
Left-Hand floor area, tidy up at the end.
2.3 Connect the negative (black) wire from the
motor wire harness to a ground point on the
passenger side of the chassis, near where the
control unit is mounted.
Connect the
positive wire
corresponding connector found on the motor
wire harness.
from Step 1.4 to the
clearviewaccessories.com.au
Sensor Wire Harness
Motor Wire Harness
Positive Wire
Negative Wire
9