ClearView RT-RT110 설치 지침 매뉴얼 - 페이지 11

{카테고리_이름} ClearView RT-RT110에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearView RT-RT110 20 페이지.

Assembly Instructions

Arm Clamp for fine

width adjustment

5. Re-install M6 ARM CLAMP BOLTS and M6 NYLON INSERT HEX NUTS back into

HUB ARMS after the SUPPORT ROD is inserted. (Do not tighten yet.)

6. Position the left and right FLAP SUPPORT RODS so the width adjustment

holes face forward horizontally. Refer Image 5.

Flap Retainer Bolt

through both parts

Flap Position Holes

Small & mid sized vehicles

Full size vehicles

Large sized vehicles

(dual axles, motorhomes..)

7. Slide FLAP CLAMPS over the FLAP SUPPORT RODS with square holes facing

away from vehicle. Do not secure with FLAP RETAINER BOLTS yet.

Refer Image 6 for orientation of flap retainer bolt hole and flap support rod

positioning holes.

NB: MUDFLAP not yet attached in Image 6.

Flap position holes

must face forward

clearviewaccessories.com.au

Flap Support Rods

Rod End Caps with

Nut and Bolts

IMAGE 6

Slide carefully

Flap End Cap

IMAGE 5