ClearView RT-RT110 설치 지침 매뉴얼 - 페이지 6

{카테고리_이름} ClearView RT-RT110에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearView RT-RT110 20 페이지.

Before you Start

CAUTION

Read through the fitting instructions before installation of Clearview Accessories.

Always install the accessory following the fitting instructions. Failure to do so may

cause damage to the vehicle or the accessory and will void your warranty.

Ensure all packaging materials are recycled and/or disposed of in accordance with

local regulations.

Safely store and protect any removed vehicle components.

Remove all metal swarf and dust from all vehicle surfaces if the surface is used for

accessory installation.

Consumer assumes all risks associated with product performance after installation.

Rock Tamers® will not protect everything and everyone from harm. Results may vary

depending on road surface and conditions, vehicle types, weather conditions,

installation, and driving input. Please apply common sense to your expectations

relating to product performance.

Car Washes; You must remove the mudflap system before entering any drive-

through car wash.

EXHAUSTS:

Any modifications to the factory-installed exhaust system may void your

manufacturer's warranty.

Adequate clearance must be maintained to prevent heat damage to the flaps. If this

cannot be achieved we suggest fitting a 90degree dump or curved aluminum heat

deflector to the tailpipe. This will divert hot gasses away from the flaps.

For vehicles with exhausts that cannot be diverted we suggest attaching an aluminum

heat shield to the mud flap clamp bolts in the vicinity of the exhaust. This will deflect

the heat while allowing the flap to move freely.

Common sense should prevail, if you feel your flaps are getting too hot because of the

exhaust then have the modification done.

FOR TECHNICAL SUPPORT CALL 03 8351 9933

WARNING