EdgeWave iPrism ERS 하드웨어 매뉴얼 - 페이지 5

{카테고리_이름} EdgeWave iPrism ERS에 대한 하드웨어 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EdgeWave iPrism ERS 7 페이지.

LEDs and Lights

•

Ethernet Interface #1/#2 Activity Light: Blinking green indicates that data is passing

through the management interface. Steady green indicates the management interface is

connected.

•

On/Off Switch: When power is not applied to the system, press this switch to power the

ERS appliance.

Important: When power is ON, always use the Exit > Shutdown option from within the

ERS System Configuration tool to power down your ERS appliance. This cleanly

terminates the current ERS services and network connections and prepares ERS to be

powered down using this button.

•

Power LED: This LED indicator illuminates when power is applied to the system.

•

HDD LED: Indicates disk activity.

•

System Fault LED: Solid green indicates normal operation. Blinking green indicates that

the system is working, but in degraded mode. This can occur when the system becomes

overheated, so check for adequate ventilation. Solid amber and blinking amber indicate

system fault. Contact St. Bernard Technical Support if this occurs.

•

System Identification LED, System Identification Button: Pressing the system

identification button causes a blue LED to light on both the front and the back of the ERS

appliance. This allows you to easily identify a single ERS appliance amongst multiple

systems.

•

Reset Button: Resets the system. It is recommended that you reset the system using the

Exit > Reboot option from within the ERS System Configuration tool. Using the Reset

button may cause data loss.

ERS Hardware Guide

Figure 3:

ERS M6200 Rear Panel