EdgeWave iPrism ERS Donanım Kılavuzu - Sayfa 5

Ağ Donanımı EdgeWave iPrism ERS için çevrimiçi göz atın veya pdf Donanım Kılavuzu indirin. EdgeWave iPrism ERS 7 sayfaları.

LEDs and Lights

Ethernet Interface #1/#2 Activity Light: Blinking green indicates that data is passing
through the management interface. Steady green indicates the management interface is
connected.
On/Off Switch: When power is not applied to the system, press this switch to power the
ERS appliance.
Important: When power is ON, always use the Exit > Shutdown option from within the
ERS System Configuration tool to power down your ERS appliance. This cleanly
terminates the current ERS services and network connections and prepares ERS to be
powered down using this button.
Power LED: This LED indicator illuminates when power is applied to the system.
HDD LED: Indicates disk activity.
System Fault LED: Solid green indicates normal operation. Blinking green indicates that
the system is working, but in degraded mode. This can occur when the system becomes
overheated, so check for adequate ventilation. Solid amber and blinking amber indicate
system fault. Contact St. Bernard Technical Support if this occurs.
System Identification LED, System Identification Button: Pressing the system
identification button causes a blue LED to light on both the front and the back of the ERS
appliance. This allows you to easily identify a single ERS appliance amongst multiple
systems.
Reset Button: Resets the system. It is recommended that you reset the system using the
Exit > Reboot option from within the ERS System Configuration tool. Using the Reset
button may cause data loss.
ERS Hardware Guide
Figure 3:
ERS M6200 Rear Panel
5