DIYRE COLOUR DUO 운영 매뉴얼 - 페이지 5

{카테고리_이름} DIYRE COLOUR DUO에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DIYRE COLOUR DUO 13 페이지. 2-channel colour channel strip

Rear Panel Description

POWER INPUT

: DC power input from the external power supply

THRU

: Used for powering multiple Duos from a single, external power supply. To daisy chain, run a 5-pin XLR

cable from the

THRU

jack of the first Duo to the

Duos can be powered by a single external power supply.

MIC INPUT

: Balanced, XLR microphone input

LINE INPUT

: Balanced, XLR/TRS combo input

OUTPUT

: Parallel XLR and TRS output jacks. Both are balanced and carry the same signal, but only one can be

used at a time. If a jack is plugged into the TRS output jack, the XLR output will be muted.

The Colour Duo is the first Palette to allow for swapping Colours without using any tools or powering down the

unit. To remove the drawer, simply loosen the two thumb screws on the front panel and pull the drawer toward

you. Removing and inserting the drawer with the power on is completely safe for the equipment. However we

recommend disengaging the

This is the recommended process for swapping Colours:

• Disengage

ACTIVE

• Loosen thumb screws and remove drawer

• Swap Colours

• Insert drawer and tighten thumb screws completely

• Engage

switch

ACTIVE

Rack or Desktop Use

You can use the Duo on a desktop or mounted in a standard 19" rack. Use the provided rubber feet for desktop

use, or the rack ears for rack mounting. Note that if you have applied the rubber feet, you will need to remove

them for rack mounting.

POWER INPUT

ACTIVE

switch before removing the drawer to prevent a pop in your speakers.

switch

jack of the next unit to be powered. Up to four