DIYRE COLOUR DUO Посібник з експлуатації - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Музичний мікшер DIYRE COLOUR DUO. DIYRE COLOUR DUO 13 сторінок. 2-channel colour channel strip
Друкувати сторінку
Rear Panel Description
POWER INPUT
: DC power input from the external power supply
THRU
: Used for powering multiple Duos from a single, external power supply. To daisy chain, run a 5-pin XLR
cable from the
THRU
jack of the first Duo to the
Duos can be powered by a single external power supply.
MIC INPUT
: Balanced, XLR microphone input
LINE INPUT
: Balanced, XLR/TRS combo input
OUTPUT
: Parallel XLR and TRS output jacks. Both are balanced and carry the same signal, but only one can be
used at a time. If a jack is plugged into the TRS output jack, the XLR output will be muted.
Using The Drawer
The Colour Duo is the first Palette to allow for swapping Colours without using any tools or powering down the
unit. To remove the drawer, simply loosen the two thumb screws on the front panel and pull the drawer toward
you. Removing and inserting the drawer with the power on is completely safe for the equipment. However we
recommend disengaging the
This is the recommended process for swapping Colours:
• Disengage
ACTIVE
• Loosen thumb screws and remove drawer
• Swap Colours
• Insert drawer and tighten thumb screws completely
• Engage
switch
ACTIVE
Rack or Desktop Use
You can use the Duo on a desktop or mounted in a standard 19" rack. Use the provided rubber feet for desktop
use, or the rack ears for rack mounting. Note that if you have applied the rubber feet, you will need to remove
them for rack mounting.
POWER INPUT
ACTIVE
switch before removing the drawer to prevent a pop in your speakers.
switch
jack of the next unit to be powered. Up to four
3