ClearWater CTA5 설치 지침 - 페이지 2

{카테고리_이름} ClearWater CTA5에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearWater CTA5 3 페이지. Crystal single lever bath filler, crystal single shroud

Dimension

Installation

MIXER BODY

WASHER

FIXING NUT

FLEXIBLE PIPES

LEFT: HOT FEED

RIGHT: COLD FEED

1: Fit the washer into the groove in the underside of the mixer body.

2: Screw the ﬂexible pipes into the mixer body, and fully hand tighten.

3: Pass the tail of ﬂexible pipes through the hole on the bath from above, and place the mixer in position on the bath, to see if any

alteration to the existing supply pipe work is necessary, make any necessary alterations to the pipe work.

4: Slide the fixing nut up the tails and onto the fixing bolt.

5: Check that the mixer body is correctly positioned, fully tighten the fixing nut.

6: Connect the water supply pipe to the tail of flexible pipes with the hot water on the left and cold water on the right.

Ø55

HANDLE

NOZZLE

2 - 2

197

108

Ø55

154

2-G3/4

CAP

ALLEN

GRUB

KEY

SCREW

CARTRIDGE

COVER

RETAINING

NUT

CARTRIDGE

MIXER BODY

To remove the cartridge.

First shut off the water supply to the tap.

1: Pull out the cap from the handle.

2: Loosen the grub screw in handle, but do not remove it.

3: Take off the handle, unscrew the cartridge cover.

4: Using a correct size spanner unscrew the retaining nut.

5: Pull the cartridge and wash it with clean running water.

6. Dry and lightly grease the seals (only use silicone grease)

7: Replace them in turn.

HANDLE