ClearWater Lights BMW K1600GT 예비 매뉴얼 - 페이지 6
{카테고리_이름} ClearWater Lights BMW K1600GT에 대한 예비 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearWater Lights BMW K1600GT 8 페이지. Billie brake light
ClearWater Lights BMW K1600GT에 대해서도 마찬가지입니다: 설치 매뉴얼 (12 페이지)
페이지 인쇄
Inertial braking:
There is an additional braking feature provided by the CAN opener
in which the brake lights automatically engage when the deceleration of
the bike reaches a threshold value, even when the brakes are not engaged
(engine braking). There are three inertial braking modes. Switching between
each mode requires the bike to be not moving and 5
consecutive presses of the rear brake foot lever (front brake released). Each
mode will be signaled by a corresponding number of flashes by the brake
light was well as by any forward running lights, if they are also installed.
- Mode 1: Inertial braking disabled. The front and/or back brake lever must
be engaged for the brake light to activate.
- Mode 2: Low sensitivity mode. The brake light will activate when the
engine braking level reaches 0.4G.
- Mode 3: High sensitivity mode. The brake light will activate when the
engine braking level eaches 0.2G. This will make the activation of the
brake light during engine braking happen more frequently, under less
deceleration. Inertial braking is disabled during standard brake light mirror
mode (Braking Mode 2) but works equally well using the California 4-flash
(Braking Mode 3) or variable flashing (Brake Mode 4) modes. In either of
these modes, the brake light will appear just as if the rider had engaged the
brake, including the programmed flashing and automatic brightness control.
Adding mechanical braking at some point during the engine braking
process provides seamless, uninterrupted action of the brake light.
Page 6