ClearWater Lights Glenda 설치 매뉴얼 - 페이지 11

{카테고리_이름} ClearWater Lights Glenda에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearWater Lights Glenda 12 페이지. Led light kit for bmw k1600gt
ClearWater Lights Glenda에 대해서도 마찬가지입니다: 설치 매뉴얼 (12 페이지), 설치 매뉴얼 (12 페이지), 설치 매뉴얼 (12 페이지), 설치 매뉴얼 (16 페이지)

페이지 인쇄

Helpful Hints:

Using a Drip Loop:

• Though our lights are sealed for ultimate all weather use, sometimes

water sneaks by. To make sure this doesn't happen, we highly suggest

using a drip loop. When installing the wiring to your lights, use a drip

loop as shown below. This will keep water from dripping directly into the

light and instead fall off before it can reach the back of the body.

• To do this just leave a bit of extra wiring and let it hang below the light.

You could make a complete loop if you like, but just make sure the wire

hangs below the light as shown below.

Posi-Products Installation Instructions:

Posi-twist (A):

1. Strip all wires to be inserted 3/4" .

2. Twist all wires together.

3. Completely unscrew the top from the Posi-twist.

4. Feed the twisted wires through the bottom portion of the Posi-twist.

5. While ensuring the wires do not slip out of the bottom of the Posi-twist,

attach the top and tighten.

Posi-tap (B):

1. Unscrew the cap of the Posi-tap (gray or large end).

2. Slide the wire you wish to tap into through the slot in the cap.

3. Re-attach the body of the Posi-tap and tighten.

4. Attach the other wire to the bottom using the same method as a Posi-Twist.

No Drip Loop

With Drip Loop

Page 11