ClearWater Lights Glenda Instrukcja instalacji - Strona 11
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Akcesoria motocyklowe ClearWater Lights Glenda. ClearWater Lights Glenda 12 stron. Led light kit for bmw k1600gt
Również dla ClearWater Lights Glenda: Instrukcja instalacji (12 strony), Instrukcja instalacji (12 strony), Instrukcja instalacji (12 strony), Instrukcja instalacji (16 strony)
Drukuj stronęHelpful Hints:
Using a Drip Loop:
• Though our lights are sealed for ultimate all weather use, sometimes
water sneaks by. To make sure this doesn't happen, we highly suggest
using a drip loop. When installing the wiring to your lights, use a drip
loop as shown below. This will keep water from dripping directly into the
light and instead fall off before it can reach the back of the body.
• To do this just leave a bit of extra wiring and let it hang below the light.
You could make a complete loop if you like, but just make sure the wire
hangs below the light as shown below.
Posi-Products Installation Instructions:
A
Posi-twist (A):
1. Strip all wires to be inserted 3/4" .
2. Twist all wires together.
3. Completely unscrew the top from the Posi-twist.
4. Feed the twisted wires through the bottom portion of the Posi-twist.
5. While ensuring the wires do not slip out of the bottom of the Posi-twist,
attach the top and tighten.
Posi-tap (B):
1. Unscrew the cap of the Posi-tap (gray or large end).
2. Slide the wire you wish to tap into through the slot in the cap.
3. Re-attach the body of the Posi-tap and tighten.
4. Attach the other wire to the bottom using the same method as a Posi-Twist.
No Drip Loop
B
With Drip Loop
Page 11