Edic ENDEAVOR 빠른 매뉴얼 - 페이지 14

{카테고리_이름} Edic ENDEAVOR에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Edic ENDEAVOR 15 페이지. Multi-purpose extractor
Edic ENDEAVOR에 대해서도 마찬가지입니다: 소유자/운영자 매뉴얼 (17 페이지)

페이지 인쇄

INTAKE FILTER BAG:

The intake filter bag has been designed to catch larger debris before it enters the open area of the waste tank. This keeps

the dump pump intake filter from clogging too fast, allowing un-interrupted flow to the dump pump.

Locate the filter bag in the waste tank, press the cord release and pull back to loosen the drawstrings. Rinse the bag out

and place back into the tank. Tighten the cord release. Always remove the bag by loosening the cord, do not pull the

elbow out.

VACUUM INTAKE FILTER AND VACUUM SHUT OFF:

The vacuum intake filter houses the float ball which is in place to shut off airflow to the vacuum motor by floating and,

eventually, blocking the vacuum intake in the event that the recovery tank over-fills. This function keeps the vacuum

motor from taking in fluids and getting damaged. Although the filter will probably not get dirty quickly, there may be a

need to remove it and clean it if you notice debris building up. Pull down on the filter to remove it and clean as needed.

Firmly press it back into place. If it is minor build up you may use a towel to wipe off the surface of the filter.

NOTE: Daily cleaning of the intake filter bag and the pump intake filter located in the

recovery tank are essential to preserving the proper function of the pump out feature. It is

up to the operator to determine a proper cleaning schedule as workloads differ from job

to job. It is advisable to inspect the filters after the completion of each job to gauge what

an appropriate cleaning schedule would be.