dji DSLRPros Nighthawk Aerial Kit 매뉴얼 - 페이지 5

{카테고리_이름} dji DSLRPros Nighthawk Aerial Kit에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. dji DSLRPros Nighthawk Aerial Kit 10 페이지.

This list will help users understand the different LED light combinations on the Phantom 1.

• Initialization: 3 steady flashing yellow lights (1,2,3, pause, 1,2,3, pause, 1,2,3, pause).

• Satellite Searching: 3 green blinks with 1-3 red blinks. This process will go down from 3 to 2 to 1

red blinks as the craft establishes a GPS lock.

• IOC Enabled: Users will see green flashing lights but intermittently have a yellow flash indicating

that it is working. Be sure to fly more than 30 feet away from the craft's home location.

• DO NOT fly with any red lights at all.

Using the FPV

DO NOT POWER on your FPV monitor or transmitter without attaching the proper antennae. In

order to function properly, your FPV monitor and Transmitter must be set to the same band and

channel. Follow these steps to properly establish the FPV connection. Not following these steps

may result in poor image quality or damage to the system.

• The FPV transmitter can be found on the outside of your craft. It is the small rectangular circuit

board with one black button. Press and hold the button until letters begin to flash on the

transmitter's display (A, B, E, and F)

• Press the button once to select your band.

• Press and hold the button until numbers return to the screen.

• Press the button to select a channel.

To turn on the FPV monitor, press and hold the power button until the DSLRPros logo is displayed

on the screen. The menu can be accessed by quickly pressing the power button twice. Scroll

through menu options using the up and down buttons. Select your option using the "M" button.

• Open the FPV monitor's menu by pressing the power button twice.

• The down arrow to select the RF menu (Small T.V.)

• Press the M button to view your band and channel settings.

• Press the M button again to select the band. Press the up or down buttons until the monitor's band

is the same as that of the transmitter's.

• Press the power button to return to the previous screen and repeat the process until all bands are

the same.

• Press the power button to exit out of the menu and use the +/- buttons to change the channel until

your receiver's channel is the same as the Transmitter's.

Once you have matched the bands and channels on the receiver to the transmitter and powered on

your GoPro, image from the GoPro will be visible on your screen.

The monitor and the GoPro must both be placed in the same video system (NTSC in the USA and

PAL in Europe) to function properly. Use the following steps to change the video system on your

monitor.

• In the menu, press the down arrow until you reach the Function menu (Crossed Tools).

• Press the M button to enter the Function menu and press the down arrow until Video System is

highlighted.

• Press the down arrow to select NTSC or PAL.

GoPro Shooting Preferences