dji DSLRPros Nighthawk Aerial Kit 매뉴얼 - 페이지 7

{카테고리_이름} dji DSLRPros Nighthawk Aerial Kit에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. dji DSLRPros Nighthawk Aerial Kit 10 페이지.

It is recommended that novice pilots learn to fly with the white plastic propellers. The carbon fiber

propellers are for experienced pilots. They are of a different construction and can be much more

dangerous for inexperienced pilots.

Proper direction for rotation is necessary when attaching propeller blades. When the front of the craft is

facing the user, the motors are numbered 1 to 4 (counter clockwise), starting with the left hand motor.

Motors 1 & 3 tighten by spinning clockwise while motors 2 & 4 tighten in a counter clockwise direction.

To attach the propellers, remove the warning discs from the motors and spin the propeller blades onto

the corresponding motor in the direction indicated by the above image. Correct propeller installation is

necessary for proper flight. Additional information can be found in the DJI User Manual.

Propeller guards are to be used for indoor situations only. Please follow the instructions below to install

prop guards.

• To install your propeller guards, carefully place your craft upside down on a stable, flat surface.

• Under each motor, you will see 4 2mm Hex screws. Remove the two outermost screws from the

base of each motor. Do not discard the removed screws.

• Use the propeller guard screws (note that these screws are longer than those that you just

removed from the P2) to secure the propeller guards to the base of the motors.

• For added security, thread the white string included with your purchase through the eyes of the

propeller guards.

10.

Updating Your Software

It is recommended that you periodically check for software updates using the DJI assistant software

application.

• Plug the Phantom 1 into your PC or Mac using the USB cable provided.

• Power on the transmitter with the throttle all the way down.

• Power on the Phantom 1.

• Open the DJI Phantom 1 software.

DSLRPros Carbon Fiber Props are NOT self-tightening.