dji DSLRPros Nighthawk Aerial Kit 매뉴얼 - 페이지 8

{카테고리_이름} dji DSLRPros Nighthawk Aerial Kit에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. dji DSLRPros Nighthawk Aerial Kit 10 페이지.

• Go to the "Upgrade" tab.

• If upgrades are available, check with DSLRPros to ensure that the upgrade is necessary before

installing.

11.

Battery Safety

It is vital to the safety of your aerial craft, yourself, and others that you practice proper battery

safety when using, charging, and storing all batteries used with your Phantom 1. Improper use,

charging, and/or storage of batteries can result in damage to the battery or personal property.

Please adhere to all battery safety guidelines in the included manuals.

• Only charge your batteries using the included charging units. Failure to do so may result in fire.

• Never charge batteries unattended.

• If you notice that a battery is swelling or ballooning, immediately discontinue the charge, remove

the battery from the charger, and observe the battery outside and away from any combustible

materials for at least 15 minutes.

• In the event of a crash, remove the battery from the craft and observe it in a safe location looking

for swelling or damage for at least 15 minutes before using the battery again.

• When storing your batteries for more than two weeks, you must reduce their charge to storage

mode. Refer to your manual for proper battery storage procedures.

• It is always recommended to charge and store your LiPo batteries in a LiPo Safe Flame Resistant

bag. Failure to do so can result in fire.

12.

Gimbal Removal & Installation

It is highly recommended that new pilots remove the gimbal before flight practice so, that in the

event of a crash while learning to fly the Phantom 1, the Tarot will not be damaged. Please refer to

the Tarot operator manual for detailed installation and removal procedures. The information

below is only supplemental to the manuals found on the Tarot website.

To remove your Tarot Gimbal from your craft you will need a set of pliers, a Phillips head

screwdriver, and both 1.5mm and 2mm Hex screwdrivers.

1) Remove the USB board. This is the small board that plugs into your GoPro. Return the screw to its

hole once the board has been removed.