dji MATRICE 200 빠른 시작 매뉴얼 - 페이지 4

{카테고리_이름} dji MATRICE 200에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. dji MATRICE 200 14 페이지.
dji MATRICE 200에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (11 페이지)

페이지 인쇄

Using Matrice 200

1. Download the DJI Assistant 2 and DJI GO 4 App

Download and install DJI ASSISTANT

http://www.dji.com/matrice-200-series

Search 'DJI GO 4' in the App Store or Google Play, and download the app to your mobile device.

First-time activation requires your DJI account and internet connection.

Internet

DJI GO 4 app supports iOS 9 (or later) or Android 4.4 (or later).

If using a DJI CrystalSky

DJI Assistant 2 supports Windows 7 (or later) or OS X 10.11 (or later).

2. Charge the Batteries

Press the release button and open the corresponding charging port cover.

Insert the Intelligent Flight Battery into the charging port to begin charging.

Charging Time: 1.5 hours*

The Intelligent Flight Battery must be fully charged before using it for the first time. Be sure to press the release button on the top of the

Charging Hub when removing the fully charged battery.

When charging is complete, the LED lights on the Intelligent Flight Battery will turn off, and the LED on the Charging Hub will show green.

Power off the remote controller before charging. When charging is complete, the LED lights on the remote controller will turn off.

The Charging Hub will sound a signal when the battery has been fully charged. The sound can be turned on or off by toggling the switch at

the bottom of the hub.

Install the battery to the aircraft and power on. Once the battery temperature is lower than 15℃, it will auto heat to maintain a temperature

between 15-20℃.

Pairing batteries is recommended. This can be done inside the DJI GO 4 app. Ensure each battery pair is charged and discharged

simultaneously to prolong their service life and for a better flight experience.

3. Prepare the Remote Controller

Unfold the mobile device holder and the antennas.

Press the power button once to check the battery level.

Low

High

Strong

Weak

2 on your computer via the website link below:

Monitor, it is recommended to use the built-in DJI Pilot app.

Charging Time: 3 hours*

Unfold

Press the button to

release the clamp.

DJI GO 4 App

Power Outlet

100-240V

(50Hz/60Hz)

* Provided charger

Place your mobile

device and adjust

the clamp to secure.

Connect your mobile

device with a USB cable.