dji MATRICE 200 빠른 시작 매뉴얼 - 페이지 6
{카테고리_이름} dji MATRICE 200에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. dji MATRICE 200 14 페이지.
dji MATRICE 200에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (11 페이지)
페이지 인쇄Mounting the Intelligent Flight Battery
Insert the battery pair.
Press the power button once to check the battery level.
Press once, again and hold to turn on/off.
Only use battery slot B when using one battery to supply power.
Make sure to press the battery remove button when removing the battery.
5. Flight
Toggle the flight
mode switch to the
P-mode.
In the DJI GO 4 App
Auto Takeoff
Watch the tutorial in the DJI GO 4 app or on the official DJI website to learn more.
Always set an appropriate RTH altitude before takeoff. Refer to the Disclaimer and Safety Guidelines for more details.
Manual Takeoff
Combination Stick Command to start/stop the motors
Return-to-Home (RC)
Same as the RTH button in the DJI GO 4 app. Brings the aircraft
back to the Home Point.
Press and hold to initiate the RTH procedure. Press again to cancel.
Rotating propellers can be dangerous. DO NOT start the motors in narrow
spaces or when there are people nearby.
Always keep your hands on the remote controller so long as the motor is still
spinning.
After landing, power off the aircraft before turning off the remote controller.
It is important to understand basic flight guidelines for the safety
of both you and those around you.
Refer to the Disclaimer and Safety Guidelines for more
information.
Power on the remote
controller and the aircraft.
Auto Landing
Return-to-Home (RTH)
OR
A
DJI GO 4
App
Launch the DJI GO 4
app and tap GO FLY.
Gimbal Working Modes
Left stick up
(slowly) to take off
B
Ready to Go (GPS)
Before taking off, ensure that the Aircraft Status
Bar in the DJI GO 4 app indicates 'Ready to
Go (GPS)' or 'Ready to Go (Vision)' if flying
indoors.
More Intelligent Flight Modes
Manual Landing
Pull left stick down (slowly)
until you touch the ground.
Hold for a few seconds to
stop the motors.
Stop motors mid-flight: Press the RTH
button while simultaneously pulling the
left stick to the bottom inside corner
and hold for three seconds. Only
stop motors mid-flight in emergency
situations when doing so can reduce
the risk of damage or injury.
No Fly Zones
Learn more:
http://flysafe.dji.com/no-fly
High
Low