dji MATRICE 200 series 유지 관리 매뉴얼
{카테고리_이름} dji MATRICE 200 series에 대한 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. dji MATRICE 200 series 2 페이지.
dji MATRICE 200 series에 대해서도 마찬가지입니다: 면책 조항 및 안전 매뉴얼 (20 페이지), 빠른 시작 매뉴얼 (15 페이지), 자주 묻는 질문 (2 페이지)
페이지 인쇄
Matrice 200 Series
Maintenance Guide
V1.0
2017.12
To ensure flight safety and optimal performance, performing comprehensive and regular maintenance is recommended. This
manual is intended to help users maintain their aircraft as well as possible and maximize reliability. Please note that the most
effective way to extend the longevity of your aircraft is to inspect your aircraft before and after each flight to check for lodged
objects and damaged parts and arrange repair if necessary.
We recommend conducting a pre and pro flight checklist each time you use the aircraft as outlined below.
I. Pre-Flight Checklist
1. Check the motors to confirm that they are rotating smoothly.
2. Check the propellers to confirm that they have not come loose.
3. Check the arm connectors to confirm that they are mounted firmly.
4. Ensure that the gimbal is rotating smoothly.
5. Ensure that the landing gears are mounted firmly and check the pins to confirm that
they are inserted fully and tightly. (Fig. 1)
6. Ensure that the SD card cover and the rear cover are closed tightly.
7. When mounting an upward gimbal, ensure the gimbal cables are tied properly to avoid
affecting the propellers.
8. An external GPS module is required when the upward gimbal is used. Ensure the GPS
cable is connected to the rear port and the cable is tied properly. (Fig. 2)
9. When using the M210 RTK, check that the RTK antenna screws have been tightened.
(Fig. 3)
II. Post-Flight Checklist
Check below parts to avoid damage from water intrusion:
1. Intelligent Flight Batteries: Check that the connectors between the batteries and
aircraft are dry. Dry the aircraft and batteries with a towel before storage.
2. FPV camera: Check that the camera is dry, especially along the roll axis where the
camera meets the gimbal frame.
3. Aircraft arms: Ensure that the arms and arm locks are dry before unlocking and
folding.
4. Rear aircraft port where pair button and USB port are housed: Keep dry and closed
while flying. Ensure this area is dry before storage.
5. Downward gimbal connector: Keep dry, avoid disconnecting a camera and leaving
the gimbal connector exposed in the rain or other wet-weather conditions.
6. Keep the gimbal and camera away from sand and water, and wipe them down if
they've been exposed to sand or water.
Check below parts to avoid damage from sand intrusion:
1. Aircraft arms: In cases where small objects like sand become lodged in the connector
or arm, use a compressed air duster to remove these objects.
2. FPV camera: Check that the camera rotates smoothly along each axis. The camera
will judder if objects are lodged inside.
3. Motors: Detach the propellers and start the motors. Listen carefully to see if there is
any abnormal noise, please replace the motors.
4. Speaker port: keep it clean.
Fig.1
Fig.2
Fig.3