dji MATRICE 200 series 유지 관리 매뉴얼 - 페이지 2

{카테고리_이름} dji MATRICE 200 series에 대한 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. dji MATRICE 200 series 2 페이지.
dji MATRICE 200 series에 대해서도 마찬가지입니다: 면책 조항 및 안전 매뉴얼 (20 페이지), 빠른 시작 매뉴얼 (15 페이지), 자주 묻는 질문 (2 페이지)

페이지 인쇄

Checking for worn and loose parts:

1. Check that the gimbal protection cable is properly affixed to the gimbal frame.

Replace it with a 0.5mm fishing line if it is damaged. (Fig. 4)

2. Check that the landing gear lock screw is tightened properly, and ensure that the

landing gear firmly locks when connected to the drone. (Fig. 5)

3. Check that the battery release button is working normally, and the battery can be

mounted firmly.

4. Check the propeller base screws are tightened. Ensure the spring elasticity is good

and no foreign objects are stuck in the spring.

5. Ensure that the frame arm connectors are rotating smoothly.

6. Keep the upward infrared sensor lens clean and avoid wear and tear.

7. Check the following parts for signs of wearing: propellers, landing gears and motors.

If these parts seem worn or damaged, please contact your reseller to schedule parts

replacements.

8. Landing gears: Check the drawn line on the landing gear when mounted to ensure

it has been installed. To determine whether the landing gear is properly mounted,

firmly pull out the landing gear. If the attempt fails, this indicates it has been properly

mounted.

9. Keep the vision system camera lenses clean and avoid scratching them.

10. Check the battery button is functioning normally. DO NOT press the button with sharp

objects.

11. Check the battery light waterproof covers and make sure the covers have no signs of

coming off.

12. Check the external GPS cable and connector to avoid damage.

13. Check the gimbal dampeners to avoid aging, cracking, or leaking. (Fig. 6)

IV. Storage Tips

1. Avoid laying the drone on the battery compartment, as this will cause damage to the

vision positioning system.

2. Be sure to store your batteries in a dry place.

3. Detach the upward single gimbal and the GPS module for storage.

V. Updating Apps and Firmware

Make sure you are using the latest firmware and apps when flying your M200 Series

drone:

1. Check the latest firmware version in the release notes:

https://www.dji.com/matrice-200-series/info#downloads

2. DJI Pilot app download link:

http://dl.djicdn.com/djipilot-official.apk

Support Center Contact Info:

http://www.dji.com/support

The content is subject to change.

Download the latest version from

https://www.dji.com/matrice-200-series

MATRICE is a trademark of DJI.

Printed in China.

Fig.4

Fig.5

Fig.6