dji MATRICE 200 series Podręcznik konserwacji - Strona 2
Przeglądaj online lub pobierz pdf Podręcznik konserwacji dla Drony dji MATRICE 200 series. dji MATRICE 200 series 2 stron.
Również dla dji MATRICE 200 series: Zrzeczenie się odpowiedzialności i instrukcje bezpieczeństwa (20 strony), Skrócona instrukcja obsługi (15 strony), Faq (2 strony)
Drukuj stronę
Checking for worn and loose parts:
1. Check that the gimbal protection cable is properly affixed to the gimbal frame.
Replace it with a 0.5mm fishing line if it is damaged. (Fig. 4)
2. Check that the landing gear lock screw is tightened properly, and ensure that the
landing gear firmly locks when connected to the drone. (Fig. 5)
3. Check that the battery release button is working normally, and the battery can be
mounted firmly.
4. Check the propeller base screws are tightened. Ensure the spring elasticity is good
and no foreign objects are stuck in the spring.
5. Ensure that the frame arm connectors are rotating smoothly.
6. Keep the upward infrared sensor lens clean and avoid wear and tear.
7. Check the following parts for signs of wearing: propellers, landing gears and motors.
If these parts seem worn or damaged, please contact your reseller to schedule parts
replacements.
8. Landing gears: Check the drawn line on the landing gear when mounted to ensure
it has been installed. To determine whether the landing gear is properly mounted,
firmly pull out the landing gear. If the attempt fails, this indicates it has been properly
mounted.
9. Keep the vision system camera lenses clean and avoid scratching them.
10. Check the battery button is functioning normally. DO NOT press the button with sharp
objects.
11. Check the battery light waterproof covers and make sure the covers have no signs of
coming off.
12. Check the external GPS cable and connector to avoid damage.
13. Check the gimbal dampeners to avoid aging, cracking, or leaking. (Fig. 6)
IV. Storage Tips
1. Avoid laying the drone on the battery compartment, as this will cause damage to the
vision positioning system.
2. Be sure to store your batteries in a dry place.
3. Detach the upward single gimbal and the GPS module for storage.
V. Updating Apps and Firmware
Make sure you are using the latest firmware and apps when flying your M200 Series
drone:
1. Check the latest firmware version in the release notes:
https://www.dji.com/matrice-200-series/info#downloads
2. DJI Pilot app download link:
http://dl.djicdn.com/djipilot-official.apk
Support Center Contact Info:
http://www.dji.com/support
The content is subject to change.
Download the latest version from
https://www.dji.com/matrice-200-series
MATRICE is a trademark of DJI.
Copyright © 2017 DJI All Rights Reserved.
Printed in China.
Fig.4
Fig.5
Fig.6