dji PHANTOM 빠른 시작 매뉴얼 - 페이지 10

{카테고리_이름} dji PHANTOM에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. dji PHANTOM 17 페이지. Led indicator description & faq
dji PHANTOM에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (14 페이지), 빠른 시작 매뉴얼 (8 페이지), 사전 매뉴얼 (6 페이지), 빠른 시작 매뉴얼 (3 페이지), 매뉴얼 (6 페이지), 빠른 시작 매뉴얼 (3 페이지), 마운팅 (2 페이지)

Mount the Landing Gear with the Compass Module if Required

If the GPS ATTI. Mode is desired, you must first mount the landing gear which contains the Compass Module.

1. Prepare the aircraft and the landing gear.

2. Mount the landing gear with the Compass Module to the right part (shown as the following chart); make sure the

5-pin cable is through the hole of the landing gear. Fix the landing gear with screws (M3x6), and then connect the

5-pin cable to the Compass Module.

3. Mount the other landing gear to the left part.

4. Fix the antenna and the 5-pin cable on both landing gear by using the white adhesive tape.

 When flying, please make sure the compass module is stationary and firm.

 If the Landing Gear with the compass module mount on has been deformed, please replace it with a new one and

mount it as the procedures above.

 The compass module is not waterproof, and not anti-oil.



DO NOT use the magnetic screwdriver. Otherwise, keep the screwdriver at least 10cm away from the compass

module, to avoid magnetic interference.

Turn on the Transmitter

1. Set the IOC and Control Mode switch to the top position.

2. Turn on the power switch of the Transmitter

Landing Gear Mounting

Compass Module Connecting

10 |