dji PHANTOM Hızlı Başlangıç Kılavuzu - Sayfa 10

Dronlar dji PHANTOM için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. dji PHANTOM 17 sayfaları. Led indicator description & faq
Ayrıca dji PHANTOM için: Hızlı Başlangıç Kılavuzu (14 sayfalar), Hızlı Başlangıç Kılavuzu (8 sayfalar), İleri Düzey Kılavuz (6 sayfalar), Hızlı Başlangıç Kılavuzu (3 sayfalar), Manuel (6 sayfalar), Hızlı Başlangıç Kılavuzu (3 sayfalar), Montaj (2 sayfalar)

Mount the Landing Gear with the Compass Module if Required

If the GPS ATTI. Mode is desired, you must first mount the landing gear which contains the Compass Module.

1. Prepare the aircraft and the landing gear.

2. Mount the landing gear with the Compass Module to the right part (shown as the following chart); make sure the

5-pin cable is through the hole of the landing gear. Fix the landing gear with screws (M3x6), and then connect the

5-pin cable to the Compass Module.

3. Mount the other landing gear to the left part.

4. Fix the antenna and the 5-pin cable on both landing gear by using the white adhesive tape.

 When flying, please make sure the compass module is stationary and firm.

 If the Landing Gear with the compass module mount on has been deformed, please replace it with a new one and

mount it as the procedures above.

 The compass module is not waterproof, and not anti-oil.



DO NOT use the magnetic screwdriver. Otherwise, keep the screwdriver at least 10cm away from the compass

module, to avoid magnetic interference.

Turn on the Transmitter

1. Set the IOC and Control Mode switch to the top position.

2. Turn on the power switch of the Transmitter

Landing Gear Mounting

Compass Module Connecting

10 |