dji PHANTOM 빠른 시작 매뉴얼 - 페이지 7

{카테고리_이름} dji PHANTOM에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. dji PHANTOM 14 페이지. Led indicator description & faq
dji PHANTOM에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (17 페이지), 빠른 시작 매뉴얼 (8 페이지), 사전 매뉴얼 (6 페이지), 빠른 시작 매뉴얼 (3 페이지), 매뉴얼 (6 페이지), 빠른 시작 매뉴얼 (3 페이지), 마운팅 (2 페이지)

1. Lower the throttle stick to the bottom position, and flip the IOC and mode control switch to the top position.

2. Turn on the power switch of the TX，When the linking is successful, the LED indicator on the TX will

change to solid red.

Turn on the TX

1. Place the aircraft on the ground

2. Open the battery compartment cover of the aircraft.

3. Put the battery into the compartment with the power cord

is outward.

Make sure to keep the throttle stick at the bottom position before the LED change to solid red!!!

4. Connect the battery and aircraft by the power lead and

make sure the ESC's work properly.

5. Keep the sticks of the TX stationary until the system start

and self-check finished, and the LED will blink according

to the control mode.

6. Put the power cable into the battery compartment.

7. Close the battery compartment cover.

Power on the aircraft

GPS & Compass Calibration

The GPS module is built-in magnetic field sensor for measuring the geomagnetic field, which is not the same

in different areas. Calibrate the compass at the first flight or fly area is far away from the previous area.

Make sure to keep away from ferromagnetic substance when calibration.

1. Quickly switch the control mode switch from Manual Mode to GPS Atti.

Mode for 6 to 10 times, The LED indicator will turn on constantly yellow.

2. Rotate your multi rotor around the horizontal axis until the LED changes to

constant green, and then go to the next step.

3. Hold your multi rotor vertically and rotate it around its vertical axis, keep

rotating until the LED turns off, meaning the calibration is finished.

4. The LED indicator will show whether the calibration was successful or not.

Make sure to use the PHANTOM after the four green LED is off!!! Please contact us if the last four green

blinks are abnormal.

7 |