1. Lower the throttle stick to the bottom position, and flip the IOC and mode control switch to the top position.
2. Turn on the power switch of the TX，When the linking is successful, the LED indicator on the TX will
change to solid red.
5.
Turn on the TX
1. Place the aircraft on the ground
2. Open the battery compartment cover of the aircraft.
3. Put the battery into the compartment with the power cord
is outward.
Make sure to keep the throttle stick at the bottom position before the LED change to solid red!!!
4. Connect the battery and aircraft by the power lead and
make sure the ESC's work properly.
5. Keep the sticks of the TX stationary until the system start
and self-check finished, and the LED will blink according
to the control mode.
6. Put the power cable into the battery compartment.
7. Close the battery compartment cover.
6.
Power on the aircraft
7.
GPS & Compass Calibration
The GPS module is built-in magnetic field sensor for measuring the geomagnetic field, which is not the same
in different areas. Calibrate the compass at the first flight or fly area is far away from the previous area.
Make sure to keep away from ferromagnetic substance when calibration.
1. Quickly switch the control mode switch from Manual Mode to GPS Atti.
Mode for 6 to 10 times, The LED indicator will turn on constantly yellow.
2. Rotate your multi rotor around the horizontal axis until the LED changes to
constant green, and then go to the next step.
3. Hold your multi rotor vertically and rotate it around its vertical axis, keep
rotating until the LED turns off, meaning the calibration is finished.
4. The LED indicator will show whether the calibration was successful or not.
Make sure to use the PHANTOM after the four green LED is off!!! Please contact us if the last four green
blinks are abnormal.
©2012
DJI Innovations. All Rights Reserved.
7 |
Друкувати сторінку