dji Robomaster S1 빠른 시작 매뉴얼 - 페이지 4

{카테고리_이름} dji Robomaster S1에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. dji Robomaster S1 10 페이지.
dji Robomaster S1에 대해서도 마찬가지입니다: 면책 조항 및 안전 매뉴얼 (4 페이지)

페이지 인쇄
dji Robomaster S1 빠른 시작 매뉴얼
5. Preparing the Gel Beads
Soak the gel beads to the size with a diameter of 5.9 - 6.8 mm. It is recommended
to use pure water, and it will take around 4 hours to finish soaking.
The average load of the gel bead container is around 430 beads. Soak the
appropriate number of gel beads according to actual usage.
A. Fill the gel bead container with the soaked gel
beads.
B. Make sure to clean the remaining water in the
container.
The size of the soaked gel beads may vary when using different types of water.
Make sure to soak the gel beads to the specific size to avoid block the launcher.
6. Preparing the Robot
Installing the Gel Bead Container
Installing and Powering On the Intelligent Battery
Insert the Intelligent Battery, and then press and hold the power button to power
it on.
Removing the Gel Bead Container