dji Flamewheel F450 매뉴얼 - 페이지 8

{카테고리_이름} dji Flamewheel F450에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. dji Flamewheel F450 11 페이지. Quadcopter with the apm2
dji Flamewheel F450에 대해서도 마찬가지입니다: 사용자 설명서 (8 페이지), 사용자 설명서 (14 페이지), 설정 (2 페이지)

페이지 인쇄

Step 5: Finalizing the Drone and KK2 Setup

Connect the battery pack to the board andfix it using

velcro you tied that before and the kk2 should start up

with some beeps emitted by ESC"s and it the kk2

should now show up a message as SAFE MODE,

and at the right side botom of display you can see the

button indicating menu option and select it by 4th

button and you can see several options like PI editor,

REceiver test etc, place your drone on very level

surface and do ACC Calibration and plug out the

battery and turn on your transmitter and move the

throttle stick to end point, press and hold 1st and 4th

buttons on your kk2, and then connect the battery

again the kk2 now should show up a message

Throttle Pass Through and ESC's should emit a

single beep after hearing that 1st beep move the

throttle stick to idle position and then you'll hear 2

DJi F450 Quadcopter How to Build? Home Built.: Page 8

more beeps and this will calibrate the ESC's. Now go

back to SAFE MODE screen and move the throttle

stick to left most side when it is idle as in picture to

arm the kk2 once it is armed move the throttle stick to

about 30% and all the motors start spinning together

note the direction of spinning of each motor, now the

1st motor should spin clockwise and 2nd should spin

counter clock wise and 3rd one clock wise and the

4th will be counter clock wise. If any motor is spinning

in wrong direction then swap any 2 wires with ESC's

wire and now it should spin inopposite direction. In

my case red coloured arms are front of my quad and

so the red left arm's motor spins clockwise and other

should go as opposite to each other.