dji Flamewheel F450 매뉴얼 - 페이지 7
{카테고리_이름} dji Flamewheel F450에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. dji Flamewheel F450 11 페이지. Quadcopter with the apm2
dji Flamewheel F450에 대해서도 마찬가지입니다: 사용자 설명서 (8 페이지), 사용자 설명서 (14 페이지), 설정 (2 페이지)
페이지 인쇄
Step 4: Installing KK2.1.5 Flight Controller and Reciever
Fix the flight controller with velcro to the centre of the
top plate. the white arrow is the front of kk2 board and
which way your'e going to fix it will determine the front
limbs or arms of your drone so make correct decesion
before placing it. connect the ESC's signal wire onto
the board's right side pins your 1st motors pins must
be connected o the 1st row on controller and so on
and the black wire should go out of the board means
the right most pins on the flight controller will be -ve
terminals so the black wire should go onto it. mount
the receiver on one of the arm and plug the wires to
the receiver and to the left side pins on the kk2.
Generally channel 3 on your receiver will be throttle,
channel 1 => Elevator , channel 2=> roll(pitch),
DJi F450 Quadcopter How to Build? Home Built.: Page 7
channel 4=> rudder and channel 5 commonly
Auxillary(aux) but you can also use that for camera
controls. In kk 2 board also same things 1st row pins
on left side will be for elevator which controls
backward and forward motions of your quad and
channel 2 means 2nd row of pins will be for roll pitch
which controlls the side movements or the rolling
actions of your drone and channel 3 will be the
throttle which controls the motors speed and finally
channel 4 for rotation of your quad at the fixed
position and aux is optional which will be on channel
5 and you can also use that for switching on and off
for self level setting.