dji Flamewheel F450 Manuel - Sayfa 7
Quadcopterler dji Flamewheel F450 için çevrimiçi göz atın veya pdf Manuel indirin. dji Flamewheel F450 11 sayfaları. Quadcopter with the apm2
Ayrıca dji Flamewheel F450 için: Kullanıcı Kılavuzu (8 sayfalar), Kullanıcı Kılavuzu (14 sayfalar), Kurulum (2 sayfalar)
Sayfayı Yazdır
Step 4: Installing KK2.1.5 Flight Controller and Reciever
Fix the flight controller with velcro to the centre of the
top plate. the white arrow is the front of kk2 board and
which way your'e going to fix it will determine the front
limbs or arms of your drone so make correct decesion
before placing it. connect the ESC's signal wire onto
the board's right side pins your 1st motors pins must
be connected o the 1st row on controller and so on
and the black wire should go out of the board means
the right most pins on the flight controller will be -ve
terminals so the black wire should go onto it. mount
the receiver on one of the arm and plug the wires to
the receiver and to the left side pins on the kk2.
Generally channel 3 on your receiver will be throttle,
channel 1 => Elevator , channel 2=> roll(pitch),
DJi F450 Quadcopter How to Build? Home Built.: Page 7
channel 4=> rudder and channel 5 commonly
Auxillary(aux) but you can also use that for camera
controls. In kk 2 board also same things 1st row pins
on left side will be for elevator which controls
backward and forward motions of your quad and
channel 2 means 2nd row of pins will be for roll pitch
which controlls the side movements or the rolling
actions of your drone and channel 3 will be the
throttle which controls the motors speed and finally
channel 4 for rotation of your quad at the fixed
position and aux is optional which will be on channel
5 and you can also use that for switching on and off
for self level setting.