dji INSPIRE 2 빠른 시작 매뉴얼 - 페이지 6

{카테고리_이름} dji INSPIRE 2에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. dji INSPIRE 2 9 페이지. Focus handwheelremote controller stand
dji INSPIRE 2에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (18 페이지), 사용자 설명서 (14 페이지), 유지 관리 및 수리 매뉴얼 (6 페이지), 면책 조항 및 안전 매뉴얼 (20 페이지), 안전 매뉴얼 (4 페이지), 매뉴얼 (2 페이지), 사용자 설명서 (5 페이지)

페이지 인쇄
dji INSPIRE 2 빠른 시작 매뉴얼
5. Prepare the Remote Controller
Unfold the mobile device holder and the antennas.
Optimal Transmission Range
Press the button to
release the clamp.
Dual frequency support makes the HD video downlink more stable. Note that the Russian only have the 2.4G frequency.
DO NOT operate more than 3 aircrafts within the same area (size equivalent to a soccer field) to prevent transmission interference.
6. Controls
The stick mode is set to Mode 2 by default (left hand throttle). The left stick controls the aircraft's elevation
and heading. The right stick controls the aircraft's forward, backward and lateral movements. To adjust the
FPV camera, press and hold the C2 Button and rotate the control dial.
Left Stick
You can change the stick mode in the DJI GO 4 app.
Remote Controller Status Indicator
RC normal but not connected to aircraft.
RC normal and connected to aircraft.
RC Slave Mode and not connected to aircraft.
6
Strong
Weak
Try to keep the aircraft inside the
optimal transmission range. If the
signal is weak, adjust the antennas
or fly the aircraft closer.
2
Place your mobile
device and adjust the
1
clamp to secure.
Connect your mobile
device with a Micro USB
cable.
3
Right Stick
Unfold
Dual Remote Controllers
You are required to link the Master
and Slave remote controllers.
Regarding the Master RC, launch
the DJI GO 4 app and enter GO FLY.
Tap
on the top of your screen
to enter the RC Settings. Set the RC
Status as 'Master', and then enter the
desired connection password.
Repeat to set Slave RC Status to
'Slave'. Then tap Search for Master
RC and connect to the Master RC
with your preset password.
RC Slave Mode and connected to aircraft.
( B...) Low battery warning / RC error.
( B—B—...) RC idle for 5 minutes.
FPV Camera Controls