dji INSPIRE 2 빠른 시작 매뉴얼 - 페이지 8

{카테고리_이름} dji INSPIRE 2에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. dji INSPIRE 2 9 페이지. Focus handwheelremote controller stand
dji INSPIRE 2에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (18 페이지), 사용자 설명서 (14 페이지), 유지 관리 및 수리 매뉴얼 (6 페이지), 면책 조항 및 안전 매뉴얼 (20 페이지), 안전 매뉴얼 (4 페이지), 매뉴얼 (2 페이지), 사용자 설명서 (5 페이지)

페이지 인쇄

10. Flight

Ready to Go (GPS)

In the DJI GO 4 App

Auto Takeoff

The aircraft will take off and hover at

an altitude of 4 feet (1.2 meters).

Return-to-Home (RTH)

Brings the aircraft back to the Home

Point. Tap again to stop the procedure.

More Intelligent Flight Modes

Tap to use TapFly (P-mode), ActiveTrack (P-mode) and more.

Watch the tutorial in the DJI GO 4 app or on the official DJI website to learn more.

Always set an appropriate RTH altitude before takeoff. Refer to the Disclaimer and Safety Guidelines for more details.

Manual Takeoff

Combination Stick Command to start/stop the motors

Return-to-Home (RC)

Same as the RTH button in the DJI GO 4 app. Brings the aircraft

back to the Home Point.

Press and hold to initiate the RTH procedure. Press again to cancel.

Determine RTH status by sound:

Single beep... Request to return, but not receive the respond

from the aircraft yet.

Double beep... RTH in progress.

Rotating propellers can be dangerous. DO NOT start the motors in narrow spaces or

when there are people nearby.

Always keep your hands on the remote controller so long as the motor is still spinning.

After landing, power off the aircraft before turning off the remote controller.

Take off from a flat surface in a wide open space, with the rear of the aircraft facing

towards you.

Intelligent landing gear will automatically raise after takeoff and lower when landing.

They can also be controlled manually using the Transformation Switch.

The aircraft will not be able to land if the landing gear does not lower.

Aircraft Status Indicator

. . . Ready to go (GPS working).

. . . Vision System on, GPS off or unavailable.

. . . P-ATTI or ATTI mode.

..... Not connected to remote controller.

Before taking off, ensure that the Aircraft Status Bar in the DJI GO 4 app

indicates 'Ready to Go (GPS)' or 'Ready to Go (Vision)' in flying indoors.

Auto Landing

The aircraft will land vertically and stop its

motors.

Gimbal Working Modes

Includes Tracking Mode, Free Mode and

Reset Mode.

Manual Landing

1. Ensure the landing gear is lowered

before landing.

Left stick up

(slowly) to take off

2. Pull left stick down (slowly)

until you touch the ground.

Hold a few seconds to stop

the motors.

. . . Low battery warning.

..... Critically low battery warning.

—— Critical error.

. . . Compass calibration required.

Raise

Lower

Stop motor mid-flight: Press the RTH

button while simultaneously pulling

the left stick to the bottom inside

corner and hold for 3 seconds. Only

stop motors mid-flight in emergency

s i t u a t i o n s w h e n d o i n g s o c a n

reduce the risk of damage or injury.