FITKIT FT098 사용자 설명서 - 페이지 12

{카테고리_이름} FITKIT FT098에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. FITKIT FT098 14 페이지.

Warning: Before cleaning or maintaining products, please be sure the power plug of the

treadmill is pulled out.

Cleaning: Comprehensive cleaning will extend the using life of the electric treadmill.

Remove dust periodically in order to keep the parts clean. Be sure to clean running belt with both

sides of the exposed portion, which will reduce the accumulation of impurities. Make sure to wear

clean athletic shoes to avoid carrying the dirty matters into running board and belt. Treadmill belts

shall be cleaned by a damp cloth with soap. And please pay attention to avoid too wet the electrical

components and running belt.

Warning:

Make sure power plug disconnect before moving motor cover away, clean the motor at

least once a year.

Running belt specialized lubricant

This electric treadmill's running board and running belt has been lubricated in factory. Friction

between the running belt and running board has a great influence to the using life and the

performance of the electric treadmill, therefore regular applying of lubricant is needed. We advise

you to check the board regularly. If the board's surface is damaged, please contact our customer

service center.

We advise using lubricant between running belt and running board with following schedule:

Lightweight user (use less than 3 hours a week) once per month;

Heavyweight use (use more than 7 hours a week) once every half month.

If the treadmill belt is too loose, there will be skid phenomenon's while running; if it's too tight, it

may reduce motor performance and harden the abrasion of roller and the running belt. You can lift

two sides of the running belt for 50-75mm when the tightness is appropriate.

Running with adjusted alignment and tightness

In order to better use the treadmill and make the treadmill functions work better, it is necessary for

you to adjust the running belt into the best condition.

Running Belt alignment

⚫ Put electric treadmill flat on the ground.

⚫ Make the electric treadmill run at a speed of about 6-8km/hour.

⚫ If the running belt is closer to the right, rotate the right adjusting bolt with 1/2 turn clockwise,

then rotate the left adjusting bolt with 1/2 turn counter-clockwise. (Picture B)

⚫ If the running belt is closer to the left, rotate the left adjusting bolt with 1/2 turn clockwise, then

rotate the right adjusting bolt with 1/2 turn counter-clockwise. (Picture A)

5. Routine Maintenance