dji Ronin-S 사용자 설명서 - 페이지 2

{카테고리_이름} dji Ronin-S에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. dji Ronin-S 7 페이지. Tethered control handle
dji Ronin-S에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (17 페이지), 빠른 시작 매뉴얼 (13 페이지), 면책 조항 및 안전 매뉴얼 (10 페이지), 사용자 설명서 (8 페이지), 사용자 설명서 (8 페이지), 사용자 설명서 (10 페이지)

Introduction

The Ronin-S/SC Phone Holder was designed to securely mount mobile devices using

adjustable bracket, allowing users to utilize their mobile device as an extended

monitor and operate ActiveTrack and Force Mobile more efficiently.

Usage

The phone holder can be used in three ways.

Method 1

Attach the phone holder to the top of the camera's hot shoe, then select ActiveTrack

through the Ronin app. Note that ActiveTrack is only usable through this method.

Installation

1. Detach the bottom of the phone holder by rotating the mounting knob.

2. Attach the phone holder to the top of the camera's hot shoe, then secure the

mobile device into the phone holder's bracket. Note that the mobile device has to

be positioned horizontally as shown below. Additionally, the mobile device should

be as close to the camera lens as possible.

3. Power on the camera and mobile device. Ensure that the frame of the camera and

mobile device are focused on the same subject. The tilt angle of the mobile device

can be adjusted by loosening the phone angle knob. After adjustment, be sure to

retighten the phone angle knob.

Balancing

1. Balancing depth for the tilt axis

a. Unlock the tilt axis and lower the camera by loosening the tilt axis knob

b. Rotate the tilt axis so that the camera lens is pointing forward. Check to make

sure the camera is not front or back-heavy. If front-heavy, move the camera

backward. If back-heavy, move the camera forward.

c. Loosen the knob under the camera mounting plate

balance

d. Tighten the knob.

2. Balancing the vertical tilt

a. Rotate the tilt axis so that the camera lens is tilting up for about 45 degrees. Check to

make sure the camera is not top or bottom-heavy. If the camera is tilted to one side,

pull the tilt arm towards the other side.

b. Loosen the knob on the tilt motor

the camera is steady without tilting up or down.

c. Tighten the knob.

d. Repeat Step 1 to balance the depth of the tilt axis. The slider on the dovetail plate is

used to record the balance position. Move the slider next to the mounting plate and

tighten the slider.

until the camera is steady.

and adjust the balance of the camera

and adjust the camera

until