EN
Introduction
The Ronin-S/SC Phone Holder was designed to securely mount mobile devices using
adjustable bracket, allowing users to utilize their mobile device as an extended
monitor and operate ActiveTrack and Force Mobile more efficiently.
Usage
The phone holder can be used in three ways.
Method 1
Attach the phone holder to the top of the camera's hot shoe, then select ActiveTrack
through the Ronin app. Note that ActiveTrack is only usable through this method.
Installation
1. Detach the bottom of the phone holder by rotating the mounting knob.
2. Attach the phone holder to the top of the camera's hot shoe, then secure the
mobile device into the phone holder's bracket. Note that the mobile device has to
be positioned horizontally as shown below. Additionally, the mobile device should
be as close to the camera lens as possible.
1
2
3. Power on the camera and mobile device. Ensure that the frame of the camera and
mobile device are focused on the same subject. The tilt angle of the mobile device
can be adjusted by loosening the phone angle knob. After adjustment, be sure to
retighten the phone angle knob.
Balancing
1. Balancing depth for the tilt axis
a. Unlock the tilt axis and lower the camera by loosening the tilt axis knob
b. Rotate the tilt axis so that the camera lens is pointing forward. Check to make
sure the camera is not front or back-heavy. If front-heavy, move the camera
backward. If back-heavy, move the camera forward.
c. Loosen the knob under the camera mounting plate
balance
3
d. Tighten the knob.
1
2. Balancing the vertical tilt
a. Rotate the tilt axis so that the camera lens is tilting up for about 45 degrees. Check to
make sure the camera is not top or bottom-heavy. If the camera is tilted to one side,
pull the tilt arm towards the other side.
b. Loosen the knob on the tilt motor
the camera is steady without tilting up or down.
c. Tighten the knob.
d. Repeat Step 1 to balance the depth of the tilt axis. The slider on the dovetail plate is
used to record the balance position. Move the slider next to the mounting plate and
tighten the slider.
2
2
until the camera is steady.
1
and adjust the balance of the camera
1
and adjust the camera
2
2
3
.
1
until
2
Imprimir página