dji Zenmuse H3-2D 사용자 설명서 - 페이지 3

{카테고리_이름} dji Zenmuse H3-2D에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. dji Zenmuse H3-2D 16 페이지.

In The Box

Gimbal

×1

The gimbal has built-in

special servos drive

module, and

independent IMU module. It controls both the tilt and the roll axis,

to enhance the attitude stabilization.

Damping Unit×1

Connect the aircraft and the gimbal, in order to reduce the

mechanical vibration. There are three types of Vibration Absorber,

the White is softest, the Black is hardest, and the Grey is in the

DJI

middle. It is recommended to use the White on

F450, not use

DJI

any on

F550, and the

PHANTOM can use any type.

Gimbal Controller Unit

(GCU)×1

Connect the gimbal controller to the autopilot system by

CAN-Bus. And Use the 3S~6S power cable to supply power for the

GCU and gimbal.

Screw Pa

ckage ×1

M2.5x6.3: For fixing the camera to the gimbal.

M2.5x5: For fixing the gimbal to the damping unit.

M3x8 (with M3 nuts and M3 spacers): For mounting the damping

unit to the aircraft.

Gimbal Video signal Cable

×1

For the gimbal controller unit and your Wireless Video

Transmission Unit connecting, transmitting the video signal.

CAN-Bus Cable×1

Use CAN-Bus to communicate with the autopilot system.

8-Pin Cable×1

For the gimbal and the GCU connecting,

Spare Package

×1

Spare Screw