dji Zenmuse H3-2D 사용자 설명서 - 페이지 5

{카테고리_이름} dji Zenmuse H3-2D에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. dji Zenmuse H3-2D 16 페이지.

Assembly

Gimbal Description

Notes:

(1)

Mack sure nothing blocks the servo driver module rotation, to avoid Servo Driver Module damage.

(2)

Clear obstacle at once if the rotating gimbal is blocked.

STEP1. Mount the Gimbal to the Aircraft or Landing Gear

The following procedure applies to DJI F450, DJI other type of aircraft or to your own aircraft. For DJI F450,

there are diagrams for your reference.

Attach the Vibration Absorber to the Top Board of Damper Unit shown in Fig.1.

Mount the Top Board of Damper Unit to the Bottom Board of aircraft; fix the M3x8screws, M3 spacers

and M3 nuts shown in Fig.2.

Plug one port of the 8-Pin cable into the 8-Pin port on the gimbal shown in Fig.3.

Tighten the M2.5x5 screws to fix the gimbal to the Bottom Board of Damper Unit shown in Fig.4.

Attach the Vibration Absorber to the Bottom Board of Damper Unit shown in Fig.5.

Make sure the damping unit is horizontally mounted and both damping boards are paralleled to the

bottom of the aircraft, further to make sure the gimbal is precisely and firmly assembled.

Notes:

(1)

This product does not include any extra aircraft, landing gear or camera, please prepare them by yourself.

Top oard of the Damping Unit

Vibration Absorber

Bottom oard of the Damping Unit

Port of 8-Pin Cable

(

)

To GCU G8

Camera Fixed Mounting

Camera Mounting Base

Servo Driver Module(Roll)

Camera Interface

Servo Driver Module(Tilt)