dji FC7BMC 사용자 설명서 - 페이지 7

{카테고리_이름} dji FC7BMC에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. dji FC7BMC 16 페이지. Motion controller

Operation

Press the power button once to check the current battery level. Recharge before using if the battery level is too low.

Press once then press again and hold to power the motion controller on or off.

LED1

LED2

Use a USB-C cable to connect a charger to the USB-C port of

the motion controller. It takes approximately 2.5 hours to fully

charge the motion controller.

The table below shows the battery level during charging.

LED1

LED2

The battery level LEDs display the power level of the battery during

charging and discharging. The statuses of the LEDs are defined below:

LED is on.

LED is flashing.

LED is off.

LED3

LED4

LED3

LED4

Battery Level

Battery Level > 80%

75% < Battery Level ≤ 80%

63% < Battery Level ≤ 75%

50% < Battery Level ≤ 63%

38% < Battery Level ≤ 50%

15% < Battery Level ≤ 38%

8% < Battery Level ≤ 15%

0% < Battery Level ≤ 8%

5V, 1A

Battery Level

0% < Battery Level ≤ 50%

50% < Battery Level ≤ 75%

75% < Battery Level < 100%

Fully charged