djm direct DJMSS406 운영 매뉴얼 - 페이지 9

{카테고리_이름} djm direct DJMSS406에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. djm direct DJMSS406 19 페이지. Scroll saw

페이지 인쇄

A scroll saw is fundamentally a "curve cutting

tool" but which can also carry out straight and

angled edge cuts. Familiarise yourself with the

following important points prior to commissioning

the saw.

• The saw does not automatically cut wood.

You must feed the wood against the saw blade

manually.

• The cutting process occurs only while the blade

is moving downwards.

• Feed the wood slowly against the saw blade as

the saw blade teeth are small and cut only while

moving downwards.

• All persons carrying out work with the saw

require training. The saw blade may break easily

during this training time while the operator is still

unfamiliar with the saw.

• The saw is best suited for sheets of wood less

than 2.5 cm thick.

• Feed the wood especially slowly against the

blade and avoid abrupt curves to prevent the

saw blade from breaking, if you wish to cut wood

sheets thicker than 2.5 cm.

• Saw blade teeth becomes blunt over time, saw

blades must be replaced. The saw blades are

sufficient for 1/2 to 2 operating time depending

upon the type of wood.

• Try and make sure that the saw blade follows

the grain of the wood in order to obtain a clean

cut.

• The saw speed must be reduced to minimum

when cutting precious and non-terrous metals.

12. Inside Cuts

Warning: Switch off the saw andremove

the mains supply plug before doing

inside cuts in order to avoid injuries

caused by unintentional activation of

the saw.

This saw is suited also to inside cuts cut not

starting at the edge of the work piece. Proceed

as follows:

• Drill a 6 mm hole in the work piece.

• Loosen the clamping screw (blade tensioner)

and release the tension in the blade.

• Place the bore hole over the saw blade slot in

the work bench.

• Install the saw blade through the hole in the

work piece and through the work blade slot, and

fasten the blade to the holders.

• When you have completed the inside cut,

remove the saw blade and then remove the work

piece from the bench.

Continuous Operation

It is possible to switch the saw on by pressing the

green "I" button for continuous operation.

In order to switch the saw off, it is necessary to

press the red "0" button.

With the continuously variable electronic speed

control, the cutting speed can be increased by

turning to the right or reduced by turning to the

left.