djm direct DJMBD13-40 원본 운영 매뉴얼 - 페이지 14

{카테고리_이름} djm direct DJMBD13-40에 대한 원본 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. djm direct DJMBD13-40 19 페이지. Bench drill

Problem

Dirt, grease, or oil on the tapered surface on the

spindle or in the chuck

Chuck falls off spindle

1. Defective or broken switch

2. Defective or damaged power cord

Motor will not run

3. Open circuit, loose connections, or burned

out motor

4. Low voltage

Motor stalls

1. Short circuit in motor

2. Incorrect fuses or circuit breakers

3. Overloaded circuit

4. Low Voltage

Cause

Remedy

Clean the tapered surface of both the chuck and

spindle with a household detergent.3. Repair

by Customer Care.

1. Take to a qualified service technician

2. Take to a qualified service technician

3. Take to a qualified service technician

4. Check the power line for the proper voltage.

Use another circuit or have a qualified

1. Take to a qualified service technician

2. Replace with correct fuse or circuit

breaker for the circuit

3. Turn off other machines and retry 4.

Check the power line for the proper

voltage. Use another circuit or have a

qualified electrician upgrade the service.