Artila Matrix 604 빠른 설치 매뉴얼 - 페이지 3
{카테고리_이름} Artila Matrix 604에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Artila Matrix 604 4 페이지.
페이지 인쇄Network Settings
To configure the network setting by serial console, you can use
command ifconfig as followed. To check current network
configuration, you can use command ipconfig
User Account Manager
To create user group and account, you can use command
usrmgr. After user's account and password are created, user can
add authentication in telnet and ftp function by using telnetdcfg
and ftpdcfg.
Telnet Configuration
Telnet is enabled without authentication as factory default. To
disable or add authentication, please use command telnetdcfg as
follow:
FTP Configuration
FTP is enabled without authentication as factory default. To
disable or add authentication, please use command ftpdcfg as
follow:
File System
User programs and files should be saved at NandFlash. The other
folders are saved as RAMDisk therefore do not save your data to
them. Under NandFlash, you will find www folder and
autoexec.bat file. Www is for web page and autoexec.bat is for
auto run program. If you have a USB disk plugged in Matrix-604,
you will find a new folder Hard Disk available.
Serial Ports Configuration
The serial port of Matrix-604 is mapped as followed
Serial 1=> USB Console (ActiveSync)
Serial 2=> Hardware Console Port (RS-232)
Serial 3=> Matrix-604 Port 1 (RS-232/422/485)
Serial 4=> Matrix-604 Port 2 (RS-232/485)
Serial 5=> Matrix-604 Port 3 (RS-232/485)
Serial 6=> Matrix-604 Port 4 (RS-232/485)
To configure serial port settings, please use command setuart as
follow:
Serial Console Configuration
The serial console port of Matrix-604 can be disabled or
redirect to other serial port by command setconsole as follow:
GPIO Control
Matrix-604 comes with five GPIO which share the serial
console port connector. Use gpioctl command to control the
GPIO port. The I/O number starts from #1 to #5 and can be
configured as input or output independently.