djpower V-4 사용자 설명서 - 페이지 13
{카테고리_이름} djpower V-4에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. djpower V-4 17 페이지. Super spark machine
페이지 인쇄•
Please properly keep the Spark Seed ID Card and corresponding Spark Seed before swiping, and
properly dispose of the invalid card after swiping and identifying.
Every Spark Seed ID Card, which is attached to the Spark Seed pouch, stores corresponding
run-time information. The run-time for 200g pouch card is 25 minutes.
Every 200g Spark Seed could output 3 minutes Spark at highest output level (Spark height
level 10).
When swiping multiple cards at one time, or swipe a new card before the machine runs
out of run-time, the run-time will be cumulative.
6.2
Fill in Spark Seed
Tear open the vacuum resealable foil pouch, and fill in the Spark Seed through the feed port on the top
of the fixture depending on the dosage needed.
Consumable Feed Port & Storage Bin
(Filling & Refilling Procedures)
•
Open the magnetic hinged lid.
•
Fill the consumable into the feed port, NOT into the
output nozzle when power off.
•
Close the lid securely after filling.
•
The capacity of storage bin is 700g.
Only use DJPOWER consumable.
•
6.3
Step of cleaning powder stuck
When the machine is stucked, you can follow the prompts on the front of the machine to clean up the
powder stuck.
Step of cleaning powder stuck
•
When the machine is stucked, please use
the manual rotation port for stucking and
rotate it in the direction shown in the
figure to clear the powder stuck.
6.4
Precaution for use
•
The Spark Seed could be only filled in and used for the DJPOWER Spark Machine after successfully
identified by swiping Consumable ID card.
•
Make sure to fill the Spark Seed through the feed port on the top of the fixture and when power
supply is off.
•
Use Dry Chemical Extinguishers once lighting a fire. DO NOT use Water-Type Extinguishers, Foam
Extinguishers or Carbon Dioxide Extinguishers.
CardID:12345678
Top-up: 25 Min
- 12 -