DK Digital AS-20-1 소유자 매뉴얼 - 페이지 10

{카테고리_이름} DK Digital AS-20-1에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DK Digital AS-20-1 13 페이지. Home theater surround system

Operating the Home Cinema Set

1. Set the mains switch (POWER) on the backside of the subwoofer to the ON position (I).

The system is now in standby mode and the red pilot lamp (STANDBY) on the front side

lights up.

2. Push the STANDBY button on the remote control in order to switch on the system. The

green pilot lamp (OPERATION) will light up.

3. Push the INPUT button in order to activate the desired input, AUX or 5.1 channel.

4. You can choose between the operation mode 2.1 (stereo with subwoofer) or 5.1 (all

speakers) using the button OUTPUT.

5. You can set the overall volume with the help of the VOLUME 56 buttons on the remote

control. Push the 5 button to increase the volume and the 6 button to reduce the

volume. While you are changing the volume, the green pilot lamp is quickly blinking.

6. For adjusting the volume of the individual speakers to each other during operation, carry

out the following steps:

—

Set the overall volume to an appropriate level.

—

Push the CEN + or – button in order to change the volume of the centre speaker.

Push the SUR + or – button in order to change the volume of the surround speakers.

Push the SUB + or – button in order to change the volume of the subwoofer.

7. Push the STANDBY button on the remote control in order to switch the system into

standby mode. The red pilot lamp will light up. To save some energy we recommend to

switch off the POWER switch on the rear panel as well when the unit is not in use.

Disposal advice

When the operating life of this device has ended it must not be disposed as

domestic waste, but in accordance with national environmental guidelines.