artisan ARTPC-SB2M 조립 지침 매뉴얼 - 페이지 5

{카테고리_이름} artisan ARTPC-SB2M에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. artisan ARTPC-SB2M 8 페이지. Dual side burner mounting bracket for artisan cart models: artpc-26, 32 and 36

페이지 인쇄

STEP 5:

Fasten the ARTP-SB2 Side Burner to the

ARTPC-SB2M Mounting Bracket with the

(2) 1/4-20 TRUSS head screws provided

in this kit. (item 4 - part 200-0057 on Page

(See figure # 5)

The FRONT fastening point is located in-

side the body of the ARTP-SB2 ahead of

the igniter module or under the gas mani-

fold depending on which side (left or right

respectively) you are mounting the Side

Burner on the cart.

The REAR fastening point is located in the

Rear Mounting Bracket installed in step 3.

The ARTP-SB2 Dual Side Burner unit

should now be permanently attached to the

cart.

STEP 6: PIPING CONNECTION

With the pipe fittings provided in the kit, it is

now time to connect the gas line from your

ARTP BBQ to the Side Burner.

REMOVE the 3/8" ODF compression fitting

on the ARTP-SB2 pressure regulator and

REPLACE with one of the 3/8" COMP. x

1/2" NPT Compression Adapters provided.

Install the 3/8"Ø x 54" long flexible stainless

gas line in the fitting and tighten the com-

pression nut.

Route the flexible gas line into the body of

the cart by going through the rubber grom-

mets you installed in the previous steps in

the cart and rear bracket. The grommets are

required to protect the gas line from the

metal raw edges.

The pipe should be fed into the body of the

cart so it can be connected to the gas line

that the ARTP BBQ is connected to.

The gas line goes between the back of the BBQ firebox and the back of the cart, so the piping will drop and will

be visible inside the cart, under the BBQ. It is not required to remove the BBQ from the cart itself for this piping

procedure.

FRONT

FASTENING

POINT

(INSIDE BODY)

REMOVE 3/8" ODF FITTING

REPLACE WITH 3/8"x1/2" NPT

ADAPTER

GAS

REGULATOR

SUPPORT

FLANGES

NEW 3/8" Ø X 54" LONG

FLEXIBLE STAINLESS GAS LINE

REAR

FASTENING

POINT

Figure # 5

SUPPORT FLANGES

GROMMETS ON BACK

BRACKET AND CART

BODY (2)

FLEXIBLE STAINLESS

GAS LINE TO CART

Figure # 6