Custom Dynamics MAGICZONE-BT 설치 지침 매뉴얼 - 페이지 2
{카테고리_이름} Custom Dynamics MAGICZONE-BT에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Custom Dynamics MAGICZONE-BT 7 페이지. Bluetooth command remote
페이지 인쇄Wiring The Remote
For joining large quantities of wires, we recommend using cage clamp connectors, (included with most Custom Dynamics LED accent lighting
Kits). The cage clamps offer easy connection of the LEDs to the Magic™ Zone Remote. Strip back enough insulation on the wires and termi-
nate as follows:
1.
RED wire with Fuse - Connect to the [ + ] Positive terminal of 12 volt battery or power source.
2.
BLACK wire - Connect to the [ - ] Negative terminal of 12 volt battery or power source.
3.
WHITE wire - Positive current connection point: Connect to the positive [ + ] wires from the LEDs in all 3 zones.
4.
RED wire - Zone 1 Connection point: the negative [ - ] wires from the LEDs from zone 1.
5.
GREEN wire - Zone 2 Connection point: the negative [ - ] wires from the LEDs from zone 2.
6.
BLUE wire - Zone 3 Connection point: the negative [ - ]wires from the LEDs from zone 3.
7.
Once wiring is completed, clean up installation and secure the module. Make sure wiring is neat and will not be pinched, frayed or cut,
when the seat is installed.
8.
Re-connect the negative battery terminal, then use the Key Fob to test the LEDs. See page 3 for Key Fob features.
Magic™ Zone-BT Wiring Diagram
Positive [ + ] Wires
From all LED's
12V Battery
Questions? Call us at: 1 (800) 382-1388
Installation Instructions - Page 2
Zone 1 = Negative [ - ]
wires from LEDs
We recommend
Cage Clamps®
Fuse
Optional Kill Switch
(Sold Separately)
Zone 2 = Negative [ - ]
wires from LEDs
Blue
Green
Red
White
Red
Black
M-TH 8:30AM-5:30PM / FR 9:30AM-5:30PM EST
Zone 3 = Negative [ - ]
wires from LEDs
Magic™ Zone 4-BT
05-2016SM