Artison LRS 소유자 매뉴얼 - 페이지 5

{카테고리_이름} Artison LRS에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Artison LRS 10 페이지. Surround satellites (left, ight, surround)

Diagram 3

Port

,-----/

Port

Place the bracket against the wall at the desired mounting location.

a. Line the bracket mounting holes up on a stud where possible. If you can not attach to

a stud follow the instructions for using dry wall anchors.

b. Use a level to make sure that the speaker is level once it is mounted. In the case of the

LRS-IW use a level to assure that the template is properly aligned before marking the

cut out hole

10. Using a pencil, mark the mounting locations on the wall by drawing through the mounting

holes in the bracket. For the In Wall LRS-IW use the supplied template to determine the

proper location and size of the cut out. Use a pencil to mark the cut out. Cut the hole for

the LRS-IW after making sure that the speaker is in the desired location and will fit into

the space without interfering with studs or other obstacles.

11. Set the bracket aside.

12. If you were not able to mount the LRS to a stud, use dry wall inserts. Using drywall

anchors create secure mounting locations for the speaker bracket. This hould be don

with any screw locations that DO NOT hit a wall stud.

Use anchors that will hold at least two times the weight of the speaker.

13. Now mount the wall bracket.

a. Pu II the speaker wire through the rectangular opening on the bracket.

b. The rectangular opening in which the wires are pulled through should be at the bottom

of the bracket.

c. Mount the bracket to the wall using drywall screws and

lor

the crews for anchors that

you installed earlier. (DO NOT OVER TIGHTEN THE SCREWS AS THIS WILL WARP THE

BRACKET AND MAKE THE LRS INSTALLATIO

DIFFICULT)

d. Use at least 1

4 "

course thread drywall screws anywhere that you are mounting to a

stud, this will insure that the bracket is held securely.