DK-TEC SP31205 사용자 설명서 - 페이지 12
{카테고리_이름} DK-TEC SP31205에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DK-TEC SP31205 15 페이지. Atv mower
페이지 인쇄
Adjustment of the motor and knife pull straps
1. The motor belt must have the correct tightening at all times.
2. The mounting bolts of
belt is tight. Then the bolts are tightened again.
3. The strap
of the knife pull
Replacing knife blades
1. See the spare parts drawing on DK-TEC's website.
2. Set the mower in
3. Put
under the mower to prevent the mower from falling down and injuring .
bricks
4. Remove the two bolts and knife blades.
5. When assembling new parts, it is done above in the reverse order.
Removing tyres
1. Lower the mower all the way down by turning the handle clockwise.
2. Remove the knife height check bolt at the engine end and lift the wheel axis.
3. Remove the split and pull off the wheel .
Refer to the engine instruction manual for engine maintenance.
IMPORTANT:
If
parts need to be changed, only use parts that meet the manufacturer's requirements. If
that do not meet the specifications are used, it may result in a safety breach or poor operation,
thereby voiding the warranty.
STORAGE
•
Before storage, it must be ensured that the machine is clean and dry.
•
The engine and fuel tap must be in
•
Lubricate all surfaces and moving parts with a little oil to avoid rust.
•
Store the machine indoors in monitored areas during heavy rain or during
are loosened and the engine is retracted until the engine
the engine
is spring-loaded and does not
highest position to
the
the
need
access the blades of the knife.
"OFF" position.
adjustment.
winter months.
the
parts
11